Ultraviolet Water Purifiers
Ultraviolet purification is a proven technology (EPA approved) that can protect your family from waterborne disease-causing microorganisms, such as bacteria, viruses, algae, and fungi. Ultraviolet (UV) disinfection works by delivering concentrated amounts of UV light energy to the reproductive mechanism of the microbe, effectively killing it. As water passes through the UV chamber, it instantly disinfects it. The only homeowner maintenance is to replace the bulb once per year.
Chlorine is widely used as a disinfectant, but it has several drawbacks. Chlorine requires constant monitoring for proper dosage, as well as a holding tank to allow proper contact time. Chlorine reacts with naturally occurring organic matter in water to form byproducts such as chloroform, a known carcinogen. In addition, chlorine leaves an objectionable taste and odor in the water. UV purifiers have none of these drawbacks - it disinfects without chemicals.
Two types of UV purifiers are available - point-of-entry, which installs on your main water line to purify all the water in your home, and point-of-use, which purify water at a single faucet.
Manufactured by R-Can Environmental, Inc., the Sterilight point-of-use ultraviolet purifiers can be used alone, or with combined with other filter configurations. See our water filter CATALOG. The stainless steel chamber has 1/4" MNPT ends. It carries a 7-year warranty on the chamber, 5 years on hardware, and 1 year on bulb.
Sterilight point-of-entry ultraviolet purifiers connect to the main water line to purify the entire household water - all faucets, showers, and baths. The stainless steel water chamber has 3/4" MNPT ends. The control module/monitor can be installed in a convenient location. Six basic models are available for 1, 2, 5, 8, 12 gpm flow rates - higher flow commercial units are also available call or email for details, a Platinum 8 GPM NSF certified system is also available. To determine your peak flow rate, time how long it takes to fill a 5-gallon bucket at an unrestricted outlet, such as an outside hose bib. You can then calculate the gallon per minute flow. For example, if it took 30 seconds (0.5 minutes) to fill, that would be 10 gallons per minute (5 divided by 0.5).
Note: it is recommended that a 5 micron or better sediment prefilter be installed ahead of the purifier. Water that is over 7 grains per gallon hard should be softened ahead of the purifier. Iron should be less than 0.3 ppm.
Notice: consumer is responsible for following any state and/or local regulations and plumbing codes pertinent to the purchase, installation and operation of our products.
California Residents: the state of California requires water treatment devices claiming health claims be tested and certified by them - our units are not. Therefore, only aethetic claims can be made on units shipping to California addresses.
California residents - click Here.
Looking for another UV Brand call or email us for a price quote.
Brochure for Sterilight UV (PDF file format)
Click for Installation Manual Sterilight UV (PDF file format)
Click for more Information on SQPA thru S12Q-PA (PDF file format)